How To Install A Leveling Lift Kit
Just about the most important modifications that can be done to a Jeep Cherokee when individuals want to start doing some off-road adventures is to lift the suspension. The most effective way to do that is to employ a Jeep lift kit for that suspension that comes with everything you'll need to take their Cherokee from the street to the wild.
How To Install A Lift Kit
It is very important understand that installing a Jeep lift kit is fairly easy for someone who knows what they are doing; it may be rather challenging for a newbie. People who are a novice to installing Jeep modifications may wish to make sure they have a slightly older mechanic around to assist. Below is a step-by-step guide on the way to install one of these Jeep lift kits.
The first task in the process is the remove the coil springs in the front of the vehicle. This is achieved by removing the small curved clip that is certainly on the spring pads. Then move the bolts that hold the lower and upper control arms on the axel. Then disconnect the foot of the shock to provide you with axle a little more room to move.
Leveling Lift Kit
After the coil springs happen to be removed the new front coil springs will need to be put into place with all the factory spring retainers (whenever they fit the new springs). Then your bolts will need to be reinstalled on the upper and lower control arms. The shock also have to be reattached to the lower mount as well. It is a good idea to show the steering wheel from side-to-side once this has been done in order to check the clearance a higher level the tires. Our recommendation is that a front wheel alignment is conducted after installing the Jeep lift kit.
After the front end has been proven in reality it is time to move to the rear of the Jeep Cherokee. The initial step in this process is to remove the rear leaf springs. These springs are held towards the axel by four different bolts, 2 of these bolts should be removed from either end.
After the bolts have been removed the newest rear leaf springs may be installed for the Jeep lift kit. These will be placed into the same place that the other ones were, however they will be curved differently compared to factory installed ones so it may take a little effort to get them into place. Once they are in place the Cherokee can be lowered.
The new Jeep lift kit might cause the factory installed brake lines to get too short, so it is crucial that you make sure they are still properly connected. If the brake lines are improperly connected new ones must be installed to be the cause of the added height.
When the Jeep lift kit continues to be installed and all the hoses, lines, and also other wiring is secure it's about time to head out in the wilderness to try out the new kit. Many people are surprised home much of a difference there is with even one inch or two more height. It is also important to understand that the lift kit can make the Jeep Cherokee somewhat looser on the highway and it may take a little while to acquire used to how it handles.